Check Connect for Windows is installed correctly

This article is for IT Support. 

You can use the Connect for Windows diagnostic page to verify that the Connect app and Authentication Agent are properly installed on student devices and that the correct user is logged in.

Important

The diagnostic page can only be used for Connect for Windows version 4.1.7 or newer.

Check diagnostics page


Open your Internet browser and go to http://127.0.0.1:5110

Check if Connect is installed

If the diagnostic page does not load, Connect for Windows may not be installed on the device.

Install Connect for Windows if needed, and try accessing the diagnostic page again.

Check the correct user is logged in

If the diagnostic page loads, but no user is logged in or the wrong user is logged in, this means the Authentication Agent may not be installed or configured correctly.

Install the Authentication Agent and check that the diagnostic page shows the correct user.

If problems persist, contact Linewize Support for further help.

Was this article helpful?
0 out of 2 found this helpful
Share

Comments

0 comments

Please sign in to leave a comment.